IT Tech Support by techxio.com
*Computer showing nothing on monitor,
*Monitor green light on but no display,
No display problem
Sometimes the computer is started but nothing happens on the screen.
I mean to say that the screen is visible only Black, it is called no display
problem in technical language. In this problem, the monitor's LED is
blinking but the display does not appear.
Possible
Reasons
1. RAM :-
This can also be a problem of Ram because the computer can not show a
display without the RAM, if the RAM is defective then the computer does not
show display.When the computer starts, the operating system loads itself in RAM
only if there is some problem in the RAM, then the Operating system does not
load and the computer does not show the display.
2. SMPS :-
It may be Power Supply Issue, there is a CPU power connector in
SMPS (Power Supply) If this connector is not working then no display shows on
monitor. see the 4 pin CPU power connector in pin
3. Motherboard
In Some Cases It may Be Motherboard
fault. some time motherboard get heat and due to this heating some component of motherboard can be damage. So please
4. CPU ( processor )
In some cases it may be processor(CPU) Fault. If processor is not working properly then "No Display" issue will occur
In some cases it may be processor(CPU) Fault. If processor is not working properly then "No Display" issue will occur
5. Monitor
Some time It may be monitor issue. Sometimes the monitor turning on and green light is also blinking or stable, but it can be the problem of picture tube of monitor.
6. CMOS battery
A single battery installed on mother board which is called CMOS battery. This battery gives the power to the watch, always update time when PC is turned off. this battery can be the reason for no display issue.
Some time It may be monitor issue. Sometimes the monitor turning on and green light is also blinking or stable, but it can be the problem of picture tube of monitor.
6. CMOS battery
A single battery installed on mother board which is called CMOS battery. This battery gives the power to the watch, always update time when PC is turned off. this battery can be the reason for no display issue.
Solution
1. First of all, clean up RAM and check again,
if the display is not present then you can check Ram by putting it on another
computer. Or check with the other Ram on the same computer.If your RAM is
checked on another computer and the display is coming to that computer, it
means your ram is correct.It is sure that your ram is right. Now you have to
check the other thing in computer
2. Now you should check another power supply in your computer
if display come then you have to purchase new SMPS (power supply) The CPU power
connector of your power supply has been damaged.So now you have to change the
power supply.But the power supply was changed even when the display did not
come, So now you read the solution No.3
3. Sometimes there is no display due to dust
accumulation in the processor.Now you have to open the processor and clear its
dust,Now connect it again on Motherboard. If the display is not present
then Read the Solution no. 4
4. Now you have to check the monitor.There is a way to check the
monitor, its name is POST (Power On Self Test). For post. first of all
disconnect VGA cable from CPU, Now turn on the monitor, If no signal
massage is coming on the monitor then your monitor is OK
5. If you have tried that 4 solutions even then
the display did not come, that means the commuter's motherboard has been
damaged. Now You have to change motherboard
So friends these are the 5
possible reason and solution for no display issue of computer. In my other post i will describe the each solution in brief. be careful while testing hardware's.
No comments:
Post a Comment